Assembly; Assembling The Handlebar And Throttle - Jonsered FC2245 Manuel D'utilisation

Assembling the handlebar and
throttle (CC 2245)
• Remove the screw at the rear of the throttle handle.
• Slide the throttle handle onto the right side of the
handlebar, (see diagram).
• Align the screw hole in the throttle handle with the hole
in the handlebar.
• Refit the screw in the hole in the rear of the throttle
handle.
• Screw the screw through the handle and handlebar.
Tighten it.
• Unscrew the knob from the handlebar mounting.
• Position the handlebar as shown. Fit the mounting
components and tighten the knob lightly.
• Put on the harness and hang the machine from the
support hook. Now make a final adjustment so that

ASSEMBLY

the machine is in a comfortable working position when
it hangs from the harness.
• Tighten the knob.
Assembling the handlebar and
throttle
(FC 2245, FC 2245W)
• Unscrew the knob from the handlebar mounting.
• Position the handlebar as shown. Fit the mounting
components and tighten the knob lightly.
Fit the right handle to the handlebar using the screw,
washer, sleeve and nut as shown. Tighten.
Put on the harness and hang the machine from the
support hook. Now make a final adjustment so that the
–
English 49