Fitting The J-Handle; Assembling And Dismantling The Two- -Piece Shaft; Assembly - Jonsered GC 2128C Manuel D'utilisation

NOTE:
Make sure unit is assembled cor-
rectly as shown in this manual.

Fitting the J-handle

S Clip the loop handle onto the shaft.
Note that the loop handle must be fitted
between the arrows on the shaft.
S Slide the spacer into the slot in the loop
handle.
S Fit the nut, knob and screw. Do not over-
tighten.
S Attach the J- -handle to the loop handle
using the three screws as shown.
S Make a final adjustment of the handle to a
comfortable working position. Tighten the
bolt/knob.
WARNING:
To avoid serious
injury, only use grass blades/grass
cutters or trimmer heads with plastic
blades when the J-handle is fitted.
Never use saw blades!
Assembling and dismantling
the two- -piece shaft

Assembly:

S Loosen the coupling by turning the knob.
S Align the tab of the attachment (A) with
the arrow on the coupling (B).
545186857 Rev. 9 5/15/12
ASSEMBLY
S Push the attachment into the coupling until
the attachment snaps into place.
S Before using the unit, tighten the knob se-
curely.
ENGINE
Dismantling:
S Loosen the coupling by turning the knob
(at least three times).
S Push and hold the button (C). While
securely holding the engine end, pull the
attachment straight out of the coupling.
C
Fitting the harness
WARNING:
brushcutter, it must always be
hooked securely to the harness.
Otherwise, you will be unable to
control the brushcutter safely.
This can result in injury to yourself
or others.
Proper harness and handlebar adjust-
ments must be made with the engine com-
pletely stopped before using unit.
B
A
When using a
English--- 10