MINN KOTA FORTREX Instructions D'installation page 10

INSTALLING THE GAS SPRING PIN
5
ITEM(S) NEEDED
#6 x 6
k. Put a 1/4-20 x 2 1/2" Screw (Item #4) in each of the
drilled locations. The Screw should pass through the
Mount Plate and the boat deck.
l. Place a Flat Washer (Item #5) and then a Nylock Nut
(Item #6) at the end of each screw as shown and
secure. Make sure all hardware is secure.
NOTICE:
To prevent seizing of the stainless steel
hardware, do not use high speed installation tools.
Wetting the screws or applying an anti-seize may
help prevent seizing. If possible, secure all sets of
mounting bolts, nuts and washers.
Installing the Gas Spring Pin
The gas assist lift mechanism in this unit is under high spring pressure when the motor is in the deployed position. Do not remove
the Bowguard from the mount without disconnecting one end of the gas spring. Failure to do this can create a condition where
accidental pulling of the Pull Grip and Rope may cause the mount to spring open rapidly, striking anyone or anything in the direct
path.
1
a. Position the motor to the stowed position with the
Pull Grip and Rope to disengage the latch bar,
allowing the motor to fold into a flat position.
b. Once in the stowed or flat position, the Gas Spring
Pin and Spacers can be installed.
10 | minnkotamotors.com
#5 x 6 #4 x 6
WARNING
Screw
Nylock Nut
Outer Arm
Proper Alignment
Outer Arm
Gas Spring Cylinder
Flat Washer
©2018 Johnson Outdoors Marine Electronics, Inc.
Deck