One for All Kameleon 10 URC-8210 Mode D'emploi page 16

(How to copy functions from your original working remote onto the
The KAMELEON 10 comes with a complete library of pre-programmed codes.
After you have set up the KAMELEON 10 for your device, you may find that
there are one or more keys that you had on the original remote control, which
do not have a place on the KAMELEON 10 keypad.
The KAMELEON 10 offers a special Learning feature that allows you to copy
almost any function from your original remote control onto the keypad of the
KAMELEON 10.
Before you start:
- Make sure your original remote is working correctly.
- Make sure neither your KAMELEON 10, nor your original remote
control is pointing at your device.
Learning (direct)
Example: To copy the "mono/stereo" function from your original TV
remote control onto the "A"-key of your KAMELEON 10.
1. Place the KAMELEON 10 and your original remote control on a flat
surface. Make sure the ends which you normally point at your device
are facing each other. Point the original remote to the front of the
KAMELEON 10 (see picture below). Keep the remotes at a
distance of 2 to 5 cm (0.8 to 2 inches).
2.
3.
4.
5.
6.
7. If you want to copy other functions within the same mode, simply repeat
steps 5 and 6 pressing the next key you want to copy by learning. If you
want to copy another function in a different mode, simply continue with
step 4 followed by steps 5 and 6.
8.
(x2)
WWW.ONEFORALL.COM
Learning Feature
KAMELEON 10)
Press and hold down the MAGIC key (for about
3 seconds) until the rabbit comes out of the hat
(the screen will change to the setup screen).
Press IR LEARN.
Press the device key (Example: TV1 key) on the KAMELEON 10
remote to select the mode to which you want to copy the
learned function.
Press the key (Example: "A" key) on the KAMELEON 10 remote
where you want to place the learned function. The IR Indicator
will blink three times and then the display will switch off.
Press and hold the key that you want to copy (Example:
mono/stereo) on your original remote control. The display
switches back on and you will see two blinks to indicate
successful learning operation.
To exit the learning mode and return to the user screen, press
the ESC key twice.
15