Burkert SE35 Notice D'utilisation page 41

3 INSTALLATION
3.5. Electrical Connections for a Supply Voltage of 230/115 VAC (option)
Remove the cover from the unit, the power supply board is on the bottom of the housing.
Pull the cable through a PG 13.5 cable gland and wire according to fig. 5. The other
connections will be the same as on the standard version § 3.4.
Sensor connection
Fig. 5 Connection diagram for controller 8035Batch 230V /115 V AC option
Important: The 230/115 VAC version doesn't allow the driver unit power supply to
!
be used for the binary data inputs and the indicator lamp output (open collector).
BATCH CONTROLLER SE35
230/115 VAC
E-10-
8035