BFT U-BASE 2 PC Mode D'emploi page 79

17-04-2015 D812032_01
For each transmitter, you have the
option of editing the key/output
association by clicking on the cell of the
associated key; adding a description by
clicking the transmitter's icon; deleting
one or more transmitters; disabling one
or more transmitters; and editing the
key/output association of a number of
transmitters by pressing "Edit".
You can search the listed transmitters using the Find field in the top right corner above the first transmitter.
NOTE. It is best to disable the transmitters shown in red
because, being Clones or Replays, they could come back if they were to be deleted from the receiver.
11. 1- Adding a block of transmitters: New from Label
Option used to add transmitters in blocks. To be able to use this option, you must be dealing with
transmitters that can be added in blocks.
The window below prompts you to enter the start code and finish code (or number of the transmitters to
be added) of the transmitters to be added and the key and output association for each. Pressing "Confirm"
starts the process of adding the transmitters. If the operation is successful, the transmitters will be added
to the receiver, otherwise an error message will come up on screen.
Manual U-Base 2 PC ver. 01 Page 79
www.BFTGateOpeners.com