Table des Matières
Publicité
Important!
Make sure to read the user's manual prior to taking the sprayer into service for the first time. The manufacturer
shall not be held liable for damages resulting from neglect to observe these instructions.
Warning!
The sprayer may only be used by well-instructed persons. When the sprayer is passed on to others, it must
definitely be accompanied by the user's manual.
The user has the responsibility for maintaining an adequate distance away from third parties, in particular
from children and domestic animals. The user carries the liability for both direct and indirect damages.
In the handling of chemicals and plant-care agents it is essential to ensure that contact with the eyes and
skin is avoided. The wearing of suitable protective clothing, a breathing mask, safety glasses and rubber
gloves is therefore imperative.
Never blow out clogged valves and nozzles with the mouth (toxication hazard!)
Chemicals and plant-care agents may not be filled into other containers (bottles, cans etc.), and must be
stored out of reach of children.
Never spray against the wind or under excessively windy conditions. Do not apply more spraying medium to
the surface to be treated than necessary.
Never use the sprayer in closed rooms. Exhaust gases can be lethal!
Notes of safety
Before each use of the sprayer, make sure that it is correctly assembled, in an undamaged condition and
operational. The use of parts which have been damaged is prohibited.
It is expressly noted that any and all alterations to the sprayer are not allowed. In the event of such
alterations, BIRCHMEIER Sprühtechnik AG disclaims any and all warranties and liabilities.
Maintenance and repair work may performed only be well-instructed personnel, or by your Birchmeier
dealer. Use exclusively original BIRCHMEIER parts.
In the event of unusual vibrations, the sprayer is to be shut down immediately. Consult your dealer.
The sprayer may not be tipped over with fuel still in the tank.
Do not let the sprayer stand exposed to the sun. It can be damaged by the effects of heat and frost.
After each use empty the sprayer and clean it thoroughly with water. Make sure that no pollution of the
environment is caused.
The chemicals or plant-care agents and their residues remaining in the tank must be disposed in
accordance with the appertaining safety regulations. For this purpose, follow the chemical manufacturer's
instructions.
Preparing the sprayer
Filling the tank
1. Inform yourself of the chemical or pesticide manufacturer's instructions on the correct dosages.
2. Make sure that you are wearing appropriate protective apparel (protective glasses, breathing mask, gloves
etc.).
3. Mix the medium in a separate tank according to the manufacturer's instructions.
4. Fill the medium tank, making sure not to spill any medium.
5. Close the cover tightly.
Preparation of the sprayer
Make sure that the safety relief valve is released.
Check to ensure that all connections have been tightly fitted.
7
Publicité
Table des Matières
