Subaru H001SAL000 Manuel D'installation page 9

8
PRE-ARRANGED JUMPER HARNESS CONNECTIONS
1. Locate the vehicle's 4-pin and 2-pin pre-fit
connections behind the vehicle's fusebox near the
kick panel area. These connectors are secured to
the vehicle wiring using breakaway tape.
(FIGURE W)
2. When the 2-pin pre-fi t connector is located, unplug
and discard the mating wire jumper. (This is used
for the power window interrupt circuit).
3. Plug the remote start pre-arranged jumper harness
4-pin and 2-pin connectors into the corresponding
pre-fi t connectors. (FIGURE W)
4. Plug the 12-pin pre-arranged harness into the 12-
pin white port on the remote engine starter ECU
(installed in previous step). (FIGURE W)
5. Plug the 5-pin antenna harness into the 5-pin black
port on the remote engine starter ECU (installed in
previous step). (FIGURE W)
6. Using one (1) of the supplied 20cm tie wraps,
bundle and secure any excess pre-arranged jumper
harness to the existing vehicle wiring.
(FIGURE X)
PART NUMBER ISSUE
H001SAL000
DATE
4 April 2014
00
FIGURE W
FIGURE X
SUBARU OF AMERICA
9 OF 17