Subaru H001SAL000 Manuel D'installation page 17

15
POST INSTALLATION CHECKLIST
1. REMOTE ENGINE START- Make sure the key is removed from the ignition switch, the engine hood is closed
and all doors and hatch are closed. Press the START button twice within 3 seconds - The vehicle's parking
lights should fl ash one (1) time, the horn should honk one (1) time and then the vehicle should crank and
start. Once started the parking lights will turn on and stay on and the transmitter button will fl ash 2 times
every 5-seconds signifying the vehicle is started.
2. SHUT DOWN WITH DOOR OPENING - While the vehicle is running under remote engine start, wait at least
fi ve (5) seconds and then confi rm that all function's (lock, unlock, etc.) operate properly on the FACTORY
transmitter. Once FACTORY transmitter functionality is confi rmed, press the UNLOCK button on FACTORY
transmitter and open any vehicle door. The remote engine starter should shut down and the transmitter
button should fl ash three (3) times indicating the system has shut down.
3. ACTIVATION WITH DOOR OPEN - Make sure the key is removed from the ignition switch and the engine
hood and hatch are closed. Open the driver's door, press the START button twice within 3 seconds - The
vehicle's ignition should power momentarily and then shut down and the vehicle's horn should honk and the
parking lights should fl ash a total of six (6) times. The vehicle should not start with any door or hatch opened.
4. BRAKE PEDAL SAFETY - While sitting in the vehicle with all doors, hood and hatch closed, restart the vehicle
using the remote engine starter and press the brake pedal. The vehicle should shut off.
5. KEY-IN-SENSE - While sitting in the vehicle with all doors, hood and hatch closed, insert the ignition key
into the ignition switch, but keep it in the off position. Activate the remote engine starter. The vehicle should
fl ash the lights as if it is going to start, but then the horn should honk two (2) times and the remote engine
starter does not attempt to start the vehicle since it senses the key in the ignition.
6. HOOD SAFETY SWITCH - Open the engine hood and activate the remote engine starter. The horn should
beep two (2) times signifying that hood safety switch is activated and the vehicle will not start.
7. HEATER / AC FUNCTION - Insert the ignition key and turn the ignition to the ON position. Preset the vehicle's
heater or air conditioning to the ON position. Then, turn the ignition off and remove the ignition key. Activate
the remote engine starter and verify that the heater or air conditioning turns on to the preset setting for
manual climate controlled vehicles and turns to the "Full Auto" setting for electronic climate control vehicles.
8. 15-MINUTE RUN TIME - Activate the remote engine starter and allow the system to run for the 15-minute
preset run time. The remote engine starter should shut the vehicle off in 15 minutes (+/- 10 seconds).
9. TRANSMITTER FUNCTIONALITY VERIFICATION - Activate the remote engine starter using both of the
supplied single button transmitters.
FUNCTIONAL TESTING IS NOW COMPLETE.
PART NUMBER ISSUE
H001SAL000
DATE
4 April 2014
00
SUBARU OF AMERICA
17 OF 17
4280563 Rev - 4/4/14