Subaru H001SAL000 Manuel D'installation page 11

9
IGNITION HARNESS CONNECTIONS, continued
8-PIN IGNITION SWITCH CONNECTIONS, continued
6. Plug the remote engine starter ignition harness 8-pin
female connector into the vehicle's ignition switch.
(FIGURE BB)
7. Reconnect the 2-pin shift interlock connector.
Carefully fold back the remote engine starter harness
8-pin foam wrapped male connector. Plug the previously
unplugged vehicle's female ignition switch connector into
the remote engine starter ignition harness 8-pin male
connector. (FIGURE CC)
8. Secure the remote engine starter harness to the vehicle's
wiring harness using one (1) of the supplied 39cm tie
wraps. (FIGURE DD)
PART NUMBER ISSUE
H001SAL000
DATE
4 April 2014
00
Factory 8-Pin Female
Ignition Switch Connector
FIGURE BB
FIGURE CC
FIGURE DD
SUBARU OF AMERICA
11 OF 17