Subaru H001SAL000 Manuel D'installation page 4

WINDSHIELD MOUNT ANTENNA INSTALLATION -
5
NON EYESIGHT EQUIPPED VEHICLES
IMPORTANT! THIS SECTION ONLY APPLIES TO VEHICLES WITHOUT THE EYESIGHT SYSTEM.
FOR VEHICLES EQUIPPED WITH THE EYESIGHT SYSTEM, DISREGARD THIS SECTION AND
PROCEED TO SECTION 6
A-PILLAR PANEL REMOVAL
1. Remove the driver's side A-pillar panel by releasing the
two (2) body clips along with the lower clips where the
A-pillar panel meets the dashboard. (FIGURE H)
2. Rotate the A-pillar panel away from the dashboard
and release the airbag tether clip from the top of the
A-pillar panel. (FIGURE I) CAUTION! Use care when
performing this step to avoid damage to the curtain
airbag. If the airbag is damaged, it must be replaced.
3. Inspect the white protective (non-woven fabric) of the
curtain airbag. If the fabric is damaged, the curtain airbag
assembly must be replaced.
ANTENNA POD MOUNTING / HARNESS ROUTING
1. Plug the 5-pin connector on the antenna harness into the
5-pin port on the antenna pod. (FIGURE J)
2. Clean glass surface near antenna mounting area with
alcohol. Remove the adhesive backing on the antenna
pod and apply the antenna to the windshield. The base of
the antenna pod (harness connection end) should line up
to the area of the windshield where the solid black fi lm and
dotted black fi lm meet and 25mm (1") left of the windshield
center mark. (FIGURE K)
PART NUMBER
ISSUE
H001SAL000
.
DATE
00
4 April 2014
FIGURE H
FIGURE J
Clean mounting
area with alcohol
SUBARU OF AMERICA
FIGURE I
FIGURE K
4 OF 17