Subaru H001SAL000 Manuel D'installation page 16

13
SYSTEM POWER-UP
1. After all connections are complete, re-connect the vehicle's negative battery terminal.
2. Start the vehicle a minimum of one (1) time using the ignition key prior to activating the remote engine start system.
This is required to allow the vehicle electronic systems to re-synchronize.
3. With the vehicle running via the ignition key, verify that the instrument cluster airbag light turns off. If the airbag light
remains on, refer to the vehicle service information for troubleshooting.
14
SYSTEM REGISTRATION
NOTE: For registration by DST-i SSM, reference immobilizer registration manual.
SDI SETUP
Plug the SDI
diagnostic plug
into the vehicle's
diagnostic
connector
REGISTRATION
Using the arrows
on the SDI select
PRESS
ENT
"Subaru Vehicle"
SDI screen will display
PRESS
"Smart System : ENT
C
Otherwise : C"
SDI screen will display
"Reg Remote Cont.
PRESS
Eng Starter
ENT
Yes: ENT / No: C"
PART NUMBER
ISSUE
H001SAL000
Insert any ignition
key into the
ignition cylinder
and turn to the
RUN position
Using the arrows
PRESS
on the SDI select
"All Other Model"
SDI screen will display
PRESS
"Confirm IGN ON
ENT
YES : ENT / NO : C "
Confirm Ignition Sw On
PRESS
Press "Ent"
ENT
DATE
00
4 April 2014
Press and hold the SDI
"Menu" and "C" buttons
simultaneously for
approximately 5 seconds
to enter stand alone mode
Using the arrows
on the SDI select
ENT
"Imm Regist"
SDI screen will display
"IMMOBILIZER
Press Ent"
SDI screen will display
"Registering...
Please Wait"
SUBARU OF AMERICA
Proceed to
"Registration"
The SDI screen
will display
PRESS
"Select Reg Sys"
ENT
Press ENT to
select Immobi Sys
PRESS
ENT
Using the arrows
PRESS
on the SDI select
ENT
"R/C E/G ST Reg"
PRESS
ENT
SDI screen will display
"Remo.con.eng.st
WAIT
regist.success"
Registration
PRESS
ENT Complete
16 OF 17