Publicité
Les langues disponibles
Les langues disponibles
WINDSHIELD MOUNT ANTENNA INSTALLATION -
6
EYESIGHT EQUIPPED VEHICLES
IMPORTANT! THIS SECTION ONLY APPLIES
TO VEHICLES EQUIPPED WITH THE EYESIGHT
SYSTEM. FOR VEHICLES WITHOUT THE
EYESIGHT SYSTEM, DISREGARD THIS
SECTION AND RETURN TO SECTION 5.
ANTENNA MOUNTING
1. Mount the antenna pod to the top left hand side of the
windshield, near the headliner and driver's side A-pillar
trim panel with the antenna pod "finger" facing the
passenger's side. Use alcohol to clean the area thoroughly.
(FIGURE N)
2. Using a ruler, ensure the top left corner of the antenna
pod will be 20mm (3/4") from the right corner of the A-pillar
trim panel in a straight line and 10mm (3/8") down from
the headliner to the upper right corner of the antenna
pod. Note: The antenna pod should be level left to right.
(FIGURE N)
3. Remove the adhesive backing and apply the antenna pod
to the windshield as described in step 2 above.
(FIGURE N)
A-PILLAR PANEL REMOVAL
1. Remove the driver's side A-pillar panel by releasing the two
(2) body clips along with the lower clips where the A-pillar
panel meets the dashboard. (FIGURE O)
2. Rotate the A-pillar panel away from the dashboard
and release the airbag tether clip from the top of the
A-pillar panel. (FIGURE P) CAUTION! Use care when
performing this step to avoid damage to the curtain
airbag. If the airbag is damaged, it must be replaced.
3. Inspect the white protective (non-woven fabric) of the curtain
airbag. If the fabric is damaged, the curtain airbag assembly
must be replaced.
PART NUMBER
ISSUE
H001SAL000
DATE
00
4 April 2014
FIGURE N
FIGURE O
FIGURE P
SUBARU OF AMERICA
10mm
20mm
FIGURE N
6 OF 17
Publicité
