Publicité
Les langues disponibles
Les langues disponibles
7
REMOTE START ECU/BRACKET MOUNTING
1. Locate the vehicle's auxiliary relay block/bracket mounted to the vehicle's
dashwall behind the vehicle's fusebox and to the left of the vehicle's brake
pedal. (FIGURE T)
2. Remove the two (2) 10mm mounting nuts. (FIGURE T)
3. Lift the auxiliary relay block bracket off of the mounting studs.
4. Position the remote engine starter ECU bracket onto the mounting studs.
(FIGURE U)
5. Install the relay block bracket back onto the mounting studs (on top of the
remote engine starter ECU bracket). (FIGURE V)
NOTE: Confi rm the remote engine starter ECU bracket is positioned
under the relay block bracket and on top of the dashwall insulation
material.
6. Verify the remote engine starter ECU bracket and relay block bracket are
properly seated, then torque the lower 10mm mounting nut, followed by
the upper 10mm mounting nut to 10.8 Nm +/- 2 Nm (1.10 Kgf-m +/- 0.2
Kgf-m, 8 ft-lbs +/- 1.5 ft-lbs).
PART NUMBER
ISSUE
H001SAL000
T
FIGURE V
DATE
00
4 April 2014
T
SUBARU OF AMERICA
FIGURE T
Mounting Studs
FIGURE U
8 OF 17
Publicité
