Subaru H001SAL000 Manuel D'installation page 13

10
HOOD SAFETY SWITCH MOUNTING
1. In the engine compartment, locate the 2-pin pre-fi t hood
safety switch connector secured to the wire harness near
the ABS Unit with breakaway tape, behind the air fi lter box
on the passenger's side of the vehicle. (FIGURE FF)
2. 2.5L (4 Cylinder) vehicles - Mount the hood safety switch
bracket to the passenger side inner/lower fender support
frame using the supplied 10mm bolt and pre-arranged
weld nut in the inner fender support. Ensure that the
supporting tongue on the bracket is seated fl at against
the top of the frame rail under the fi nisher panel while
tightening the 10mm bolt. (FIGURE GG)
3. 3.6L (6 Cylinder) vehicles - Locate the A/T control module
mounted on the passenger's side fender support and
remove the bracket mounting bolt closest to the front of
the vehicle. Mount the hood safety switch bracket to the
A/T control module bracket using the previously removed
10mm bolt. Ensure that the supporting tongue on the
bracket is seated fl at against the top of the frame rail
under the fi nisher panel while tightening the 10mm bolt.
(FIGURE HH)
4. Torque the mounting bolt to 10.8 Nm +/- 2 Nm (1.10 Kgf-m
+/- 0.2 Kgf-m, 8 ft-lbs +/- 1.5 ft-lbs).
PART NUMBER ISSUE
H001SAL000
DATE
4 April 2014
00
FIGURE FF
Temporarily remove the plastic clip
to prevent damage to the felt cover
FIGURE GG
Temporarily remove the plastic
clip to prevent damage to the felt
cover
FIGURE HH
SUBARU OF AMERICA
T
T
13 OF 17