Subaru H001SAL000 Manuel D'installation page 14

10
HOOD SAFETY SWITCH MOUNTING, continued
5. Using the supplied foam tape, wrap the vehicle's hood
safety switch wiring starting where it meets the main
vehicle wiring near the ABS Unit. (FIGURE II)
6. Securely mount (snap-in) the supplied hood safety switch
into the bracket and plug the vehicle's pre-fi t 2-pin female
hood switch connector to the base of the hood safety
switch. (FIGURE II)
7. Install the supplied adhesive backed cable clip to the
angled vehicle frame rail approximately 6cm to the left of
the hood safety switch mounting bolt. Coil any excess
hood safety switch wiring and secure with the cable clip.
(FIGURE JJ)
8. 3.6L (6 Cylinder) vehicles - Using one (1) of the supplied
20cm tie wraps, secure the hood switch harness to the
factory wiring. (FIGURE KK)
PART NUMBER
ISSUE
H001SAL000
DATE
00
4 April 2014
Foam Tape
FIGURE II
FIGURE JJ
3.6L (6 Cylinder) Vehicles Only
FIGURE KK
SUBARU OF AMERICA
Cable Clip
14 OF 17