Subaru H001SAL000 Manuel D'installation page 10

9
IGNITION HARNESS CONNECTIONS
8-PIN IGNITION SWITCH CONNECTIONS
1. Adjust the tilt/telescoping steering column all the way out and
down.
2. Locate the 8-pin ignition switch connector and the 2-pin shift
interlock connector on the right side of the steering column and
unplug both connectors. Carefully pull the connectors down and
away from the steering column. (FIGURE Y)
3. Using a Phillips screwdriver, remove the two (2) screws securing
the large metal bracket to the left side of the steering column.
(Figure Z)
4. Using (2) of the supplied 39cm tie wraps, secure the remote start
ignition harness to the vehicle harness running up the center of
the large bracket. The fi rst tie wrap should secure the harness
in front of the bracket, at the white tape ring. The second tie
wrap should secure the harness behind the bracket, at the white
tape ring. (FIGURE AA)
5. Using a Phillips screwdriver, reinstall the two (2) screws securing
the large metal bracket to the left side of the steering column.
Torque the screws to 4 Nm +/- 1 Nm (0.41 Kgf-m +/- 0.1Kgf-m,
2.95 ft. lbs. +/- 0.74 ft. lbs.). (FIGURE Z)
NOTE: Use care to make sure the screws are not over tightened.
Over tightening the screws will result in damage to the
screws.
PART NUMBER
ISSUE
H001SAL000
DATE
00
4 April 2014
FIGURE Y
SUBARU OF AMERICA
8-Pin Ignition
Switch Connector
2-Pin Shift Interlock
Connector
FIGURE Z
FIGURE AA
10 OF 17