Handling; Maintenance - MC Crypt IN THE MIX Notice D'emploi

12. Handling

• Never plug the mains plug into a mains socket immediately after the device has been taken from a cold to a
warm environment. The resulting condensation could destroy the device. Allow the device to reach room tem-
perature before connecting it. Wait until the condensation water has evaporated.
• Never disconnect the mains plug from the mains socket by pulling on the cable. Only unplug it by pulling on the
plug.
• Unplug the power supply if you do not use the device for an extended period of time.
• For safety reasons, disconnect the mains plug from the mains socket in case of a thunderstorm.
• Do not listen to excessively loud music for a long period of time. This may damage your hearing.

13. Maintenance

Periodically verify the technical safety of the device, e.g. check for damage to the power cable or the housing.
If you have reason to believe that the device can no longer be operated safely, disconnect it immediately and
make sure it is not unintentionally operated. Pull the power plug out of the power socket!
It must be assumed that safe operation is no longer possible if:
• there is visible damage to the device or to the power line
• the device no longer works
• the device has been stored for a long time under unfavourable conditions or
• after the device has been exposed to extraordinary stress caused by transport
Make sure to observe the following safety instructions before cleaning or servicing the McCrypt "IN THE MIX" DJ
set:
The device is maintenance-free and you should therefore never open it. Live components may
be exposed if covers are opened or components are removed. If you do open it, the guarantee
will be rendered invalid.
All connected devices must be disconnected from the mains before servicing or repairs.
Repairs may only be carried out by qualified personnel who are familiar with the hazards invol-
ved and the relevant regulations.
The device's outside should only be cleaned with a soft, dry cloth or a brush. Never use any aggressive cleaning
agents or chemical solutions that may damage the surface of the housing.
51