MC Crypt IN THE MIX Notice D'emploi page 41

Only put the switch in the PHONO position if a record player is connected. Select LINE for any
other devices.
The input signal is reproduced distorted if the switch position is incorrect. There is the risk of
damage to the connected amplifier or the loudspeakers. Only press the switch when the mixer is
not switched on. If no device is connected to the sockets, set the switch to LINE.
(49) DIRECT DECK 1 + 2 OUT
At the RCA output DECK 1, the signal of CH1 is output, and at RCA output DECK2 the signal of CH2. The
two signals are not influenced by the mixing console control. This is where you can connect, e.g., another
mixing console.
(50) BALANCE MASTER OUT connection
XLR connection for the downstream amplifier. The signal is controlled by the mixing console controls
(51) LED CD
The LED CD is lit when no CD, CD-R or CD-RW is in the CD tray.
This function is active only when CD was selected as playback source.
Display
(A) Playback source
Indicates the playback source selected
(B) TRACK display
Shows the track number currently being played or the selected track. When the storage medium is read, the total
number of tracks on it (max. 999) is displayed.
(C) Playback display
Depending on playback status, the symbols PLAY, PAUSE and SEARCH light up.
(D) ELAPSED, TOTAL, REMAIN display
The respective display lights up, depending on the TIME display selected (elapsed track time > total remaining
time > track remaining time).
40