Miller Spoolmatic 30A Manuel Du Propriétaire page 14

3-7. Installing Gas Supply
6
5
4
Tools Needed:
1-1/8, 5/8 in
OM-1213 Page 12
1
2
3
OR
Argon Gas
7
1
2
3
8
CO Gas
2
Obtain gas cylinder and chain to
running gear, wall, or other station-
ary support so cylinder cannot fall
and break off valve.
1 Cap
2 Cylinder Valve
Remove cap, stand to side of valve,
and open valve slightly. Gas flow
blows dust and dirt from valve.
Close valve.
3 Cylinder
4 Regulator/Flowmeter
Install so face is vertical.
5 Gas Hose Connection
Fitting has 5/8-18 right-hand
threads.
6 Flow Adjust
Typical flow rate is 20 cfh (cubic feet
per hour). Check wire manufactur-
er's recommended flow rate.
Make sure flow adjust is closed
when opening cylinder to avoid
damage to the flowmeter.
7 CO Adapter
2
8 O-Ring
Install adapter with O-ring between
regulator/flowmeter and CO
cylinder.
ssb3.1* 5/94 − ST-158 697-A
2