Miller Spoolmatic 30A Manuel Du Propriétaire page 13

3-5. Connecting To 24 Volt Weld Control
Tools Needed:
1-1/8, 5/8 in
3-6. Connecting To 115 Volt Weld Control
6
Wrapper Off
Tools Needed:
1-1/8, 5/8 in
2
1
5
3
Left Side
2
5
4
3
3
1
5
4
1 Gas Hose
2 10 ft (3 m) Gas Hose With 5/8
in Adapter Fitting
Connect fitting to gun/feeder gas
hose and remaining end to regula-
tor/flowmeter (see Section 3-7).
3 24 Volt Weld Control
4 Trigger Control Cord
Insert plug into receptacle, and
tighten threaded collar.
5 Weld Cable
Connect to positive (+) weld output
terminal on welding power source
according to its Owner's Manual.
ST-150 917-A
1 115 Volt Weld Control
2 Gas Hose
Connect to Gas outlet on control.
3 10 ft (3 m) Gas Hose
Remove 5/8 in adapter fitting from
hose. Connect according to weld
control Owner's Manual.
4 Trigger Control Cord
Insert plug into receptacle, and
tighten threaded collar.
5 Weld Cable
6 Positive (+) Weld Output
Terminal In Control
Connect weld cable to positive (+)
weld output terminal in weld control.
Reinstall weld control wrapper.
Ref. ST-149 549-A / ST-149 966-A
OM-1213 Page 11