Miller Spoolmatic 30A Manuel Du Propriétaire page 12

3-3. Installing Wire Spool And Threading Welding Wire
6
Tools Needed:
3-4. Rotating Canister
OM-1213 Page 10
8 7
11
9
Rear View
1
2
10
5
1
1 Top Cover
2 Canister
3 Canister Cover
4 Thumbscrew (Canister Cover)
Loosen thumbscrew and remove
cover.
5 Wire Spool
Loosen wire from spool, cut off bent
wire, and pull 6 in (150 mm) of wire
off spool.
6 Pressure Roll Assembly
Lift arm and open pressure roll
assembly.
7 Canister Inlet Guide
8 Drive Roll Groove
9 Contact Tip
Thread wire through canister inlet
guide, along drive roll groove, and
out contact tip.
Install spool so wire feeds off
bottom.
10 Spool Brake Thumbnut
If necessary, turn thumbnut coun-
terclockwise slightly to install spool.
11 Thumbscrew (Canister
Rotation)
Loosen thumbscrew to rotate can-
3
ister (see Section 3-4).
Close and secure pressure roll
assembly.
Reinstall top cover and canister
cover.
4
ST-150 436
1 Canister
Loosen canister rotation thumb-
screw (see Section 3-3). Move can-
ister to desired position. Tighten
thumbscrew.
ST-150 433-A