Mounting The Cutting Blade; Starting / Stopping The Engine - Stihl FCS-KM Notice D'emploi

English

Mounting the Cutting Blade

Lay the power edger on its back so
N
that the blade mounting (1) faces
up.
5
6
4
2
3
Insert the stop pin (2) into the
N
hole (3) as far as stop – apply slight
pressure and turn back and forth
10
together with the thrust plate (4)
until the pin slips into position and
blocks the shaft.
Fit the combination wrench (5) on
N
the screw (6).
Loosen the screw clockwise (left-
N
hand thread) and take it out.
6
9
4
9
11
Remove the thrust washer (4).
N
Position the blade (9) on the thrust
N
plate (10).
WARNING
Collar (see arrow) must engage the
blade's mounting hole.
Fit the thrust washer on the
N
shaft (11) and block the shaft.
Fit the screw (6) in the shaft
N
counterclockwise and tighten it
down firmly.
Starting / Stopping the
Engine
Starting the engine
To start the engine, basically follow the
instructions for use for the KombiEngine
or basic power tool!
10
Place the machine on the ground in
N
a secure position
The blade must not touch the ground or
any other objects – risk of accident!
Assume a firm stance – possibilities:
N
standing, bending or kneeling
Press the machine firmly against
N
the ground with the left hand – do
not touch the control elements on
the control handle while doing so –
see instruction manual for the
KombiEngine or basic power tool
FCS-KM