Mounting The Cutting Attachment - Stihl FSB-KM Notice D'emploi

English
5
b
4
6
Slide the deflector (3) onto the drive
N
tube (4) so that the bead (a) on the
drive tube engages the guide (b) in
the deflector.
Push the deflector (3) into position
N
until the set screw (5) engages.
Tighten down the clamp screw (6)
N
firmly.
10
Mounting the Cutting
Attachment
Placing power tool on the ground
3
Switch off the engine.
N
Lay your trimmer on its back with
N
the loop handle and shroud pointing
down and the output shaft facing up.
Thrust plate
1
3
2
4
The thrust plate (1) is shipped with the
PolyCut 5 - 3. It is only required for this
mowing head.
STIHL AutoCut 11 - 2
Pull the thrust plate (1), if fitted, off
N
the shaft (2).
STIHL PolyCut 5 - 3 mowing head
Slip the thrust plate (1) over the
N
shaft (2) and engage the hex
recess (3) on the external
hexagon (4).
FSB-KM