Approved Kombiengines - Stihl FCS-KM Notice D'emploi

English
operator. This ensures that cuttings and
other debris are directed away from the
power tool and operator.
Edging
Start the engine.
N
Start the cut at no less than half
N
throttle and continue cutting at full
throttle.
Hold and guide your power tool so
N
that the blade is vertical.
Cut steadily so that the engine is not
N
lugged down – do not apply force.
Operate at no more than a normal
N
walking pace.
Do not push the blade into the
N
ground.
8
Always walk forwards when cutting,
N
do not pull the unit towards you.
Cut at a steady pace to avoid having
N
to make several passes.
1
Use the gunning sight (1) to line the
N
blade up with the edge of the bed.

Approved KombiEngines

KombiEngines
Only use KombiEngines supplied by
STIHL or explicitly approved by STIHL
for use with the KombiTool.
This KombiTool may be operated only in
combination with the following
KombiEngines:
STIHL KM 55 R, KM 56 R, KM 85 R,
KM 90, KM 90 R, KM 94 R, KM 100,
KM 100 R, KM 110, KM 110 R, KM 130,
KM 130 R, KMA 130 R
WARNING
Loop-handled power tools must be
equipped with a barrier bar.
Brushcutters with split drive tube
This KombiTool may also be mounted to
STIHL brushcutters (basic power tools)
with a split drive tube (T models).
Operation of this KombiTool is therefore
also permitted on the following power
tool model:
STIHL FR 130 T
WARNING
Refer to the power tool's instruction
manual for use of the barrier bar.
FCS-KM