Trouble Shooting; Repair Service - Grizzly EKS 1835-2 QTX Traduction De La Notice D'utilisation Originale

GB

Trouble shooting

Problem
Device does not start
Chain does not rotate
Inferior cutting
performance
Saw runs with difficulty,
chain comes off
Chain becomes hot,
smoke development
during sawing,
discoloration of the rail

Repair service

Our Service-Center will also carry out any
non-guarantee repair work for a charge.
We will be happy to give you a quote.
We will only work on units that have been
sent in with the appropriate packaging,
postage paid.
The transportation risk is borne by the
sender.
122
Possible cause
Mains voltage defective
House protection fuse
activated
Defective On/Off switch
Worn carbon brushes
Defective motor
Chain brake blocks saw
chain
Incorrectly mounted saw
chain
Saw chain (5) blunt
Chain tension insufficient
Chain tension insufficient
Too little chain oil
Fault correction
Check plug socket, cable, line
and plug, where appropriate,
repair by electrical specialist.
Check house protection fuse,
see note
Repair by customer service
Repair by customer service
Repair by customer service
Check chain brake.
Possibly release chain brake
Mount saw chain correctly
Sharpen cutting teeth or place
on new chain
Check chain tension
Check chain tension
Check oil level and, where
appropriate, refill with chain oil,
check oil automatic system
and, where appropriate,
clean oil outflow duct or have
repaired by customer service
Caution: Please, in no case, send defec-
tive devices with filled oil tank. Completely
empty the tank. Possible material dam-
ages (oil runs out if device is placed on its
side or upside down!) and/or fire damages
during transport are borne at the expense
of the sender.
Devices sent in with freight collect - by
bulk freight, express or with other spe-
cial freight - are not accepted�
We will dispose of tools free of charge.