Trouble Shooting; Fault Correction - Grizzly EKS 1835-20 Traduction De La Notice D'utilisation Originale

GB

Trouble shooting

Problem
Device does not start
Chain does not rotate
Inferior cutting
performance
Saw runs with difficulty,
chain comes off
Chain becomes hot,
smoke development
during sawing,
discoloration of the rail
106
Possible cause
Mains voltage defective
House protection fuse
activated
Defective On/Off switch
Worn carbon brushes
Defective motor
Chain brake blocks saw
chain
Incorrectly mounted saw
chain
Saw chain (5) blunt
Chain tension insufficient
Chain tension insufficient
Too little chain oil

Fault correction

Check plug socket, cable, line
and plug, where appropriate,
repair by electrical specialist.
Check house protection fuse,
see note
Repair by customer service
Repair by customer service
Repair by customer service
Check chain brake.
Possibly release chain brake
Mount saw chain correctly
Sharpen cutting teeth or place
on new chain
Check chain tension
Check chain tension
Check oil level and, where
appropriate, refill with chain oil,
check oil automatic system
and, where appropriate,
clean oil outflow duct or have
repaired by customer service