Operating The Chainsaw; Switching On; Checking The Chain Brake; Checking The Oil Automatic System - Grizzly EKS 1835-2 QTX Traduction De La Notice D'utilisation Originale

Operating the
Switch on the chainsaw only when
chain bar, saw chain and sprocket
chain wheel covering are correctly
assembled.
Ensure the voltage of the mains
connection agrees with the label
on the device.
Make sure you have a secure
stance.
Before starting, ensure that the
electric chainsaw is in contact with
no objects.

Switching on

Check before the start, whether
sufficient chain oil is in the tank
and, if necessary, refill with chain
oil (see Chapter Operation Start).
1. Release the chain brake, where
you shift the brake arm (4) back
against the front grip..
2. Form a loop from the end of the
extension cable and hang this
into the tension relief (18) on the
rear grip.
3. Connect the device to the mains
voltage
4. Hold the electric chainsaw firmly
with both hands, with the right
hand on the rear grip and the left
hand on the front handle. Thumb
and finger must close securely
over the handles.
5. For switching on, activate the
switch-on block (11) with the right
thumb and then press the On/Off
switch (10), the electric power saw
runs with highest speed. Release
the switch-on block again.
6. The power saw switches off
when you release the On/Off
chainsaw
switch again. Switching for con-
tinuous running is not possible

Checking the chain brake

The saw chain does not turn if the
chain brake is engaged.
1. Release the chain brake by
shifting the brake arm (4) over
against the front grip.
2. Place the electric chainsaw onto
a solid, flat surface. It must not
contact any objects.
3. Connect the device to the mains
voltage.
4. Hold the electric chainsaw firmly
with both hands, with the right
hand on the rear grip and the left
hand on the front handle. Thumb
and finger must close securely
over the handles. (see
5. Turn on the electric chainsaw.
(See "Switching On").
6. Activate the chain braking lever
(4), with running motor, with the
left hand. Chain should stop
abruptly..
7. Once the chain brake is work-
ing properly, release the on/off
switch and the chain brake.
If the chain brake does not func-
tion correctly, you must not use
the electric chainsaw. A slack
saw chain leads to danger of in-
jury�
Return the electric chainsaw to
our Service-Center for repair
Checking the oil automatic sys-
tem
Check the oil level and the oil automatic
system before commencement of work.
GB
).
113