Setting Functions With The Control Panel; Quick User Guide (068-13884) See Fold-Out Page; Possible Configurations And Operating Modes - Balluff BOD 26K LB04-S115-C Instructions De Service Et De Montage

The LEDs (illustr. 11) indicate the selected menus and configurations.
BA ZA
Q Q
1 2
I OK
C FA
SET
Illustr. 11
15500272
7.2

Setting functions with the control panel

First, activate set-up mode  push
When green LED flashes, select function (according to table 7.2.2) with
When all functions are set (table 7.2.2), leave set-up mode  push
then stored and the sensor is in Run mode.
7.2.1

Quick user guide (068-13884) see fold-out page

7.2.2

Possible configurations and operating modes

No. Action Picture
follows
1 Q : Set as switching input or output
1
No
Q
Q
1
I OK
action
C FA
2 Q : Teach-in of 1
st
1
Q Q
1
OK
I
C FA
push
1x
50
LED Colour In operating mode
BA Green Operating indicator (LED lights up
when sensor is ready for use)
ZA Red
Q Yellow Lights up when Q
1
is active
Q Yellow Lights up when Q
2
I Green Lights up when Q
Q enable input function is active
1
OK Green Good Target (lights up when object
is detected and in measuring
range)
C Green Lights up when sensor is program-
med as master or slave
FA Green Lights up when Q
or Q
active
SET and
Action Reaction / Status indicator „ZA" (red)
Switch with ON, when Q
2
OFF, when Q
SET
switching point
Save mea- ON, if measured value valid
2
sured value OFF, if measured value invalid
SET
with
SET
When the key is released, the current measured value is stored as the 1
point of the Q switching output.
1
input/output
1
output is active
2
trigger input or
1
autom. centre
1
autom. zero function is
1
simultaneously for 3 s (or longer), until LED BA (green) flashes.
SET
is defined as switching output
1
is defined as input
1
No. 834826 E Edition 1310; Replaces edition 1111; Subject to modification
operating instructions
In configuration mode
LED flashes when set-up mode
is active.
Status indicator:
Lights up when function is active.
Off, when function is not active.
During teach-in: confirmation
signal
Table of functions in chapter 7.2.2
onwards explains the significance
of the Q , Q , I, OK, C and FA
1 2
LEDs in set-up mode.
.
and simultaneously. All settings are
Factory setting
Q = switching output
1
(„ZA" = ON)
Switching point at half
measuring range
Mounting and
switching
st