Assembling The Unit - Stihl BR 500 Notice D'emploi

Vibration behavior is influenced by the
condition of the AV elements – check the
AV elements at regular intervals.
Shut off the engine before rectifying
problems.
Maintenance, replacement, or repair of
the emission control devices and
systems may be performed by any
nonroad engine repair establishment or
individual. However, if you make a
warranty claim for a component which
has not been serviced or maintained
properly or if nonapproved replacement
parts were used, STIHL may deny
coverage.
For any maintenance please refer to the
maintenance chart and to the warranty
statement near the end of the instruction
manual.
BR 500, BR 550, BR 600

Assembling the Unit

Mounting the Control Handle
1
2
Pull the two halves of the clamp
N
apart.
Push the control handle (1) onto the
N
blower tube (2).
1
2
3
Line up the control handle (1) with
N
the tube's seam – as shown.
Secure the control handle (1) with
N
the screw (3) so that it can still be
moved on the blower tube (2).
Mounting the Blower Tubes
BR 500
1
2 3
Depending on your size and reach:
N
Push blower tube (1) up to the
appropriate mark on the blower
tube (2).
Rotate the blower tube (1) in the
N
direction of the arrow and engage it
in the appropriate slot (3).
BR 550, BR 600
2
3
Depending on your size and reach:
N
Push blower tube (1) up to the
appropriate mark on the blower
tube (2).
Rotate the blower tube (1) in the
N
direction of the arrow and engage it
in the appropriate slot (3).
English
1
7