Spark Arresting Screen In Muffler; Rewind Starter; Storing The Machine - Stihl BR 500 Notice D'emploi

Spark Arresting Screen in
Muffler
In some countries the muffler is
equipped with a spark arresting screen.
If the engine is down on power,
N
check the spark arresting screen in
the muffler.
Wait for the muffler to cool down.
N
1
2
1
Loosen the screws (1).
N
Remove the scoop (2).
N
Remove the spark arresting
N
screen (3).
Clean the spark arresting screen. If
N
the screen is damaged or heavily
carbonized, fit a new one.
Refit the spark arresting screen.
N
Fit the scoop.
N
BR 500, BR 550, BR 600

Rewind Starter

To help prolong the wear life of the
starter rope, observe the following
points:
Pull the starter rope only in the
N
direction specified.
Do not pull the rope over the edge of
N
the guide bushing.
Do not pull out the rope more than
N
specified.
Do not allow the starter grip to snap
N
back, guide it back into the housing
slowly – see chapter on "Starting /
Stopping the Engine."
Have a damaged starter rope replaced
by your dealer before it breaks
completely. STIHL recommends that
you have servicing and repair work
carried out exclusively by an authorized
STIHL servicing dealer.
3

Storing the Machine

For periods of 3 months or longer
Drain and clean the fuel tank in a
N
well ventilated area.
Dispose of fuel properly in
N
accordance with local
environmental requirements.
Run the engine until the carburetor
N
is dry – this helps prevent the
carburetor diaphragms sticking
together.
Thoroughly clean the machine – pay
N
special attention to the cylinder fins
and air filter.
Store the machine in a dry, high or
N
locked location, – out of the reach of
children and other unauthorized
persons.
English
21