Festo DGE-ZR-RF Série Notice D'utilisation page 40

DGE− −ZR−RF
To fasten the work load:
Use the fastening thread or slot nuts (accessories).
S
Place the useful load so that the tilting
S
torque of the force parallel to the move
ment axis and lever arm a" remains low.
Useful loads with their own guide:
Adjust the guides of the useful load and
S
the DGE−...−ZR−RF so that they are exactly
parallel.
Only in this way can you avoid over
loading on the slide (permitted forces
è chapter Technical data").
The service life of the DGE−...−ZR−RF will
then remain as expected.
With hard and stiff work loads (steel):
Note
If the aluminium slide becomes bent against
a buckled useful load, the service life of the
guide will be reduced.
S Make sure that the mounting surface of
the useful loads is even to within
t 0.01 mm.
For useful load geometries with projection in
the longitudinal direction of the slide:
Make sure that the useful load does not
S
strike against the motor.
40
a
Fig. 15
m
DGE
Fig. 16
Fig. 17
Fig. 18
Festo DGE− −ZR−RF 0906d English
F
t