Festo DGE-ZR-RF Série Notice D'utilisation page 39

DGE− −ZR−RF
When fitting centre supports:
Position the centre supports at equal
S
distances over the complete axis length,
not only over the stroke path.
Fasten the centre supports on the
S
DGE−...−ZR−RF as shown in Fig. 13.
If the device is tilted, the sliding blocks of
the centre supports will slide into the
groove at any point on the profile.
Make sure that the centre supports are
S
outside the positioning range of the slide
by pushing it once over the complete
positioning path.
Tighten the fastening screws evenly.
S
Festo DGE− −ZR−RF 0906d English
40
63
Fig. 13
Fig. 14
Dia. 25
39