Festo DGE-ZR-RF Série Notice D'utilisation page 35

DGE− −ZR−RF
5 Installation
Mechanical installation
Do not modify the settings of screws and
S
threaded pins if there is no direct
requirement to do so in these operating
instructions.
Fit the motor onto the axis in accordance
S
with the assembly instructions for the
motor mounting kit recommended in the
catalogue.
Preparing the product for fitting
Note
Please note that in the case of heavy loadings the axis must not be fastened
only by the front cover.
Excessive tensile loads will cause the cover screws to be pulled out.
With use of the upper threaded holes in the
end caps:
Ensure the maximum screw−in depth of
S
7 mm (with use of HP−25: use screw
M4x10).
Festo DGE− −ZR−RF 0906d English
Fig. 5
Fig. 6
35