Burkert 8311 Manuel D'installation page 28

 ProGramminG
to define the behaviour of
each transistor output if the
measuring range is exceeded
or an error is displayed:
- CONT: the output reacts
according to the settings
made within menu CAL
1OUT or CAL 2OUT
- ON: the corresponding cir-
cuit is closed immediately (is
opened as soon as the pres-
sure is again within the range
or the error is cancelled)
- OFF: the corresponding cir-
cuit is opened immediately (is
closed as soon as the pres-
sure is again within the range
or the error is cancelled).
to define the behaviour
of the current output if the
measuring range is exceeded:
0......9
*
CAL
0.500
ENTER
ENTER
BRGR
BGLO UNIT
if mode on or off has been set within cal fail for out1 and/
0......9
or out2, the settings made within cal 1out and/or cal 2out
*
are not taken into account.
CONT
CAL
ENTER ENTER
1 OUT
FAIL
0......9
ON
ENTER
1 OUT
OFF
ENTER
1 OUT
CAL
ON
ENTER
ENTER
CODE
CODE
0......9
OFF
ENTER
CODE
0......9
*
Pressure transmitter 8311
2.500
ENTER
BGHI UNIT
0......9
*
Only available on versions
with transistor outputs
CONT
ENTER
2 OUT
0......9
ON 0......9
ENTER
2 OUT
OFF
ENTER
2 OUT
9876
ENTER
CODE
CONT
ENTER
mA
22
ENTER
mA