Burkert 8311 Manuel D'installation page 19

8311
calibration mode (see p.22)
Access to the programming of all the parameters (unit, transistor outputs,
filter, 4-20 mA output, bargraph, behaviour of the outputs if the pressure
is outside the measuring range and/or when an error is displayed, access
code to the Calibration and Test modes).
From the Calibration mode, you can go back to the Normal Mode.
Reminder:
1 bar = mbar
1000 14.5038
1 bar = ft H O in. H
2
33.4553 401.463
test mode (see p.32)
Entering a theoretical pressure value to test the configuration program-
med in the Calibration mode. Access to zero point adjustment, K-factor
adjustment, current output adjustment, reset of the Calibration and/or
Test modes. From the Test mode, you can go back to the Normal Mode.
psi atm kPa
0.98692 100
O in. Hg kp/cm
2
29.53 1.01972
1
MPa mH O
2
0.1 10.1972
2
mmHg
750.064