Pentair STA-RITE POSI-CLEAR RP Guide De L'installation page 7

Les langues disponibles

Any time the filter tank is opened, and/or alement assembly is removed, be sure to generously coat the O-ring

with silicone lubricant before reassembling the unit. DO NOT USE PETROLEUM BASED LUBRICANTS BE-

CAUSE THEY HAVE A DETERIORATING EFFECT ON RUBBER.

12. Replace drain cap and reinstall High Flow™ manual air relief valve drain hose if used.

E. REPLACING CARTRIDGE ELEMENT

Cartridge element life will vary with pool conditions such as bather load, wind, dust, etc. You can expect an average

media life of three (3) years under normal conditions.

F. CLEANING THE HIGH FLOW™ MANUAL AIR RELIEF

VALVE

1. Turn the pump off and shut off any automatic controls to ensure

that the system is not inadvertently started during servicing.

2. OPEN THE HIGH FLOW™ MANUAL AIR RELIEF VALVE UNTIL

IT SNAPS INTO THE FULL OPEN POSITION, THEN WAIT

UNTIL ALL PRESSURE IS RELIEVED.

3. With the relief valve attached to the filter tank, pull out the locking

tabs and remove the valve stem and cover assembly with a

counterclockwise and lifting motion, see Figure 3.

4. Clean debris from the valve stem and body. Verify that the filter

tank's air passage is open by inserting a 5/16 in. drill bit through

the valve body. Verify that the O-ring are in good condition, properly

positioned, and lubricated with a silicone base lubricant.

5. Reinstall the valve stem and cover assembly with a downward and

clockwise motion until it snaps into position.

LIMITED WARRANTY : 2 YEARS

Further details : www.pentairpooleurope.com

NOTE

Figure 3.