Rs-485 Termination; Protocol; Baud Rate Setting - Abus TV7602 Notice D'installation

B. RS-485 Termination
st
The 1 DIP of SW2 is used for 100Ω termination.
st
Set on 1 DIP of SW2 only by the last connected camera from the loop (CAM n).
Even in case of only one camera, set ON 1
C. Protocol
rd TH
The 3 , 4 of DIP SW2 above are used for Protocol Setting.
Factory Default: Pelco-D or Pelco-P (Auto detection)
rd th
DIP SW2 - 3 4
OFF / OFF
ON / ON
D. Baud Rate Setting
th th
The 7 , 8 SW of DIP SW2 is used for Baud Rate setting.
With DIP SW2 Baud Rate can be changed to 4800bps, 9600bps.
Factory Default: 2400bps.
th
DIP SW2-7
OFF
OFF
ON
ON
nd th th
* The 2 , 5 , 6 of DIP SW2 are not used.
st
-DIP of SW2.
Pelco-D or Pelco-P
Maxpro protocol
th
DIP SW2-8
OFF
ON
OFF
ON
66
BAUD RATE
Not Used
2400bps
4800bps
9600bps