B. RS-485 Afslutningsmodstand
DIP Switch'ens 10. Pin anvendes til 100 Ω tilslutning af RS485-Bus.
Stil Pin'en kun ved det sidste ved Bus tilsluttede kamera/apparat på ON (se billede CAM n). Stil
kontakten på ON, hvis du kun anvender ét kamera.
C. Protokol
7. og 8. Pin af DIP kontakt anvendes til indstilling af protokol:
Fabriksindstilling: Pelco-D eller Pelco-P (automatisk genkendelse)
7. og 8. Pin kontakt 2
OFF / OFF
D. Baud Rate-indstilling
9. Pin af DIP kontakt anvendes til indstilling af Baud Rate.
Fabriksindstilling: 2400bps.
th
DIP SW1 9
OFF
ON
Pelco-D eller Pelco-P
BAUD RATE
2400
9600
165