Stainless Steel Surfaces; Light Bulbs; Warming Lamps - Monogram ZV36SSJSS Manuel Du Propriétaire

Do not use a steel wool pad; it will scratch
Stainless
the surface.
Steel
To clean the stainless steel surface, use warm
Surfaces
sudsy water or a stainless steel cleaner or
(on some polish. Always wipe the surface in the direction
of the grain. Follow the cleaner instructions for
models)
cleaning the stainless steel surface.
To change the light bulbs:

Light Bulbs

1. Grasp the outer trim ring and twist until
2. Grasp the bulb and twist until reaching the
3. Replace with the same wattage, type and
4. Replace the outer trim ring by inserting the
The warming lamps are located on the
Warming
underside of the hood.
Lamps
These 120 volt, 175 watt, par 38 infrared heat
lamp bulbs, with standard base, are available
at some specialty lighting stores.
These infrared bulbs can also be ordered from
your Monogram supplier.
Order bulb no. WB08X10029.
49-80775-2
reaching the unlock position. Then pull the
ring straight out.
unlock position. Then gently pull the bulb
straight out.
size bulb. Wear gloves. Do not touch bulb
with your bare fingers.
These 120 volt, 50 watt halogen bulbs with a
GU10 base are available at specialty lighting
stores and home building centers.
Order bulb no. WB08X10052.
two retaining tabs into the two tab slots,
pressing the ring flush with the surface of
the hood insert and twisting until reaching
the lock position.
Care and Cleaning
Professional Vent Hood
To inquire about purchasing stainless steel
appliance cleaner or polish, or to find the
location of a dealer nearest you, please call
our toll-free number:
Monogram Preferred Service: 800.444.1845
Monogram.com
NOTE: If warming lamps are not desired,
additional cooktop lighting can be obtained
by replacing the infrared bulbs with standard
incandescent bulbs with up to 100 watt
maximum ratings, with standard bases. These
bulbs are available at specialty lighting stores.
7