Troubleshooting Tips - Monogram ZVC48LSS Manuel Du Propriétaire

Hotte encastrable et adaptable
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Before you
call for
service
49-80565-5
Save time and money! Review the charts on the following pages first and you may not need to
call for service.
Problem
Possible Causes
Fan automatically
turns on and can not
Fan does not operate
A fuse may be blown or a circuit
when turned on
breaker tripped.
The power disconnect switch inside
Fan fails to circulate
air or moves air
slower than normal
air is required for exhausting
appliances to operate to rating.
The motor is probably overheating
and on
harmful to the motor.
Light will not stay on
high setting
The hood controls are
not operating
Sequential presses
of the light or
fan buttons will
sometimes change
the setting from the
to the highest setting,
or from the highest
lowest setting
When pressing the
For your convenience, it is normal
for the lights and fan to remember
to turn on the light,
their last setting when you press
the fan comes on
instead

Troubleshooting Tips

Custom Hood Insert
What To Do
The Sensor feature will automatically turn
the fan on at the MED setting if cooking
temperatures become too hot. The fan will
stay on for a minimum of 3 minutes and
to an appropriate level.
Replace fuse or reset circuit breaker.
the switch on.
problem, call for service.
Check with local building codes, which
may require or strongly advise the use
of makeup air. Visit Monogram.com for
available makeup air solutions.
and on cycling continues, call for service.
Use 120 volt, 50 watt halogen bulbs with
a GU10 base and make sure they are
inserted securely. See the Light bulbs
section.
Disconnect power to the hood by removing
in the home fuse box. Wait 30 seconds to
allow the CORRECTLY hood controls to
reset and then replace the fuse or move
the circuit breaker back on.
It is normal for the light and fan buttons
to cycle around through the settings so
that you can easily set the controls to the
desired setting.
If you want only the lights on, press the
"FAN +" (or the "FAN –" ) button until the
next time, only the lights will function.
9

Publicité

Table des Matières
loading

Table des Matières