Pelgrim IF960RVS Notice D'utilisation page 50

USE
EN 12
Pan recognition
• An electronic sensor detects if a pan is present or absent on the
cooking zone. If the type of pan is unsuitable for magnetic induction
cooking or if the pan is too small (see Minimum pan diameter), the
adjacent pan detection symbol is displayed.
• If during cooking a pan is removed from the cooking zone without
having first returned the relative knob to "0" position, the power
value, previously set and shown on the relative display, will be
automatically replaced with the symbol.
• If the pan is repositioned correctly on the cooking zone, the pan
detection symbol switches Off and cooking will resume normally;
otherwise, after 10 minutes, the symbol will switch Off, the knob
will have to be returned to "0" position and a new power value set
before the cooking zone can be used again.
• If a knob is turned to any position before placing a pan on the
cooking zone, the relative display shows the set power value and
then immediately replaces it with the pan detection symbol (the
cooking zone stands by for 10 minutes). If in the meantime a pan is
placed correctly on the cooking zone, cooking will begin; otherwise
the cooking zone does not activate and the pan detection symbol
switches Off. To reactivate the cooking zone, the relative knob must
be returned to "0" position and a new power value set.
Power distribution
• The maximum applicable power is distributed among the active
cooking zones.
• The first power level set takes priority over the next settings on
the other zones. On activating the last cooking zones, the values
on the displays will start to flash and a double beep will sound,
automatically showing the highest power level supplied.
• If the power setting of any of the cooking zones is manually
reduced, the difference in power will be redistributed among the
remaining cooking zones.
• Power is distributed automatically among the left cooking zones
and the middle and right cooking zones.