Operation; General - Hatco Ultra-Glo Manuel D'installation Et D'utilisation

English

General

Use the following information to operate Ultra-Glo
WARNING
Read all safety messages in the IMPORTANT SAFETY
INFORMATION section before operating this equipment.
CAUTION
Standard and approved manufacturing oils may smoke up
to 30 minutes during initial startup. This is a temporary
condition. Operate unit without food product until smoke
dissipates.
Controls
Strip heaters come standard with controls mounted to the unit
or with optional remote mounted controls. The following is a list
of the available controls for the strip heaters.
I/O (ON/OFF) Toggle Switch—Turns power on and off to
the heating elements and/or the lights (depending on control
configuration).
Infinite Control—Turns on the power and controls the
temperature of the heating elements. The infinite control is
available on remote control enclosures only.
NOTE: Units with factory installed control boxes cannot be
equipped with infinite controls.
Lights I/O (ON/OFF) Toggle Switch—Turns power on and off
to the lights.
Indicator Light—Illuminates when power is on, shuts off when
power is off.
NOTE: Dual units require remote indicator lights.
NOTE: Toggle switches cannot be used on circuits that exceed
15 amps. Infinite controls cannot be used on circuits
that exceed 12.2 amps.
Startup
1. Turn on the heating element(s). The indicator light (if
equipped) will illuminate and the heating elements will
energize.
• If unit is equipped with a I/O (ON/OFF) toggle switch,
move the toggle switch to the I (ON) position.
• If unit is equipped with an optional infinite control(s), turn
the control to the desired setting.
NOTE: Allow 15–20 minutes to reach operating temperature.
2. On models equipped with display lights, move the Lights
I/O (ON/OFF) toggle switch to the I (ON) position.
CAUTION
BURN HAZARD: Some exterior surfaces on unit will get
hot. Avoid unnecessary contact with unit.
Form No. UGAM-0718
Strip Heaters.
®
NOTE: Refer to the OPTIONS AND ACCESSORIES section
Shutdown
1. Move the I/O (ON/OFF) toggle switch to the O (OFF)
position or turn the optional infinite control(s) to the O
(OFF) position.
• The indicator light (if equipped) will shut off and the
heating elements will shut down.
2. On models equipped with display lights, move the Lights
I/O (ON/OFF) toggle switch to the O (OFF) position.
21
Attached Control Box
I/O (ON/OFF)
Toggle Switch
Remote Control Enclosure
Electronic Infinite Control
Lights I/O (ON/OFF)
Toggle Switch
Controls
for remote control enclosure information.

OPERATION

Lights I/O (ON/OFF)
Toggle Switch
Indicator Light
Indicator Light