Operation; General - Hatco Glo-Ray GR2A Series Manuel D'installation

OPERATION

General

Hatco Glo-Ray Designer Infrared Foodwarmers are designed
for ease of operation. Use the following information and
procedures to operate the unit.
WARNING
Read all safety messages in the IMPORTANT SAFETy
INFORMATION section before operating this equipment.
CAUTION
BURN HAzARD: Some exterior surfaces on unit will get
hot. Use caution when touching these areas.
Remote Control Enclosure (RMB)
All models are available with a remote control enclosure (RMB).
Each heating element is controlled by an ON/OFF Toggle
Switch or an optional adjustable infinite control. Models
equipped with lights have an additional toggle ON/OFF switch
for controlling the lights. The following is a list of the available
controls.
ON/OFF (I/O) Toggle Switch—Turns power on and off to the
heating elements and/or the lights (depending on control
configuration).
Infinite Control—Turns on the power and controls the output
of the heating elements.
Lights ON/OFF Toggle Switch—Turns power on and off to the
lights.
Indicator Light—Illuminates when power is on, shuts off when
power is off.
NOTE: Toggle switches cannot be used on circuits that exceed
15 amps. Infinite controls cannot be used on circuits
that exceed 12.2 amps.
Startup
1. Turn on the heating element(s). The indicator light (if
equipped) will illuminate and the heating elements will
energize.
• If unit is equipped with a ON/OFF (I/O) toggle switch,
move the toggle switch to the ON (I) position.
• If unit is equipped with an optional infinite control(s), turn
the control to the desired setting.
NOTE: Allow 15–20 minutes to reach operating temperature.
2. On models equipped with display lights, move the light
ON/OFF (I/O) toggle switch to the ON (I) position.
ON/OFF (I/O)
Toggle Switch
ON/OFF (I/O)
Toggle Switch
Remote Control Enclosures
Shutdown
1. Move the ON/OFF (I/O) toggle switch to the OFF (O)
position or turn the optional infinite control(s) to the
OFF (O) position.
• The indicator light (if equipped) will shut off and the
heating elements will shut down.
2. On models equipped with display lights, move the light
ON/OFF (I/O) toggle switch to the OFF (O) position.
18
English
RMB Series
Indicator Light
Infinite
Control
RMB2 Series
Indicator
Infinite
Light Control
Form No. GR2AM-1116