Operation; General - Hatco GLO-RAY Manuel D'installation

English

General

Glo-Ray Curved Infrared Strip Heaters are designed for ease
®
of operation. Use the following information and procedures to
operate the unit.
WARNING
Read all safety messages in the IMPORTANT SAFETY
INFORMATION section before operating this equipment.
BURN HAZARD: Some exterior surfaces on unit will get
hot. Use caution when touching these areas.
Standard and approved manufacturing oils may smoke up
to 30 minutes during initial startup. This is a temporary
condition. Operate unit without food product until smoke
dissipates.
Controls
Curved Infrared Strip Heaters come standard with a remote-
mounted control box. The following is a list of the controls in
the control box.
ON/OFF (I/O) Toggle Switch—Turns power on and off to the
heating elements and the LED light channels.
Heat Control Knob—Infinite-style switch that controls the
temperature of the heating element.
POWER ON Indicator Light—Illuminates when power is on,
and shuts off when power is off.
Form No. GR5ALM-0716
CAUTION
Startup
1. Move the ON/OFF (I/O) toggle switch to the ON (I) position.
• The POWER ON indicator light will illuminate, the
heating element will energize, and the LED light
channels will illuminate.
2. Turn the Heat Control Knob to the desired setting.
3. Allow 30 minutes to reach operating temperature before
holding preheated food product underneath the strip
heater.
POWER ON
Indicator Light
ON/OFF (I/O)
Toggle Switch
GR5A Series Control Box
Shutdown
1. Move the ON/OFF (I/O) toggle switch to the OFF (O)
position.
• The POWER ON indicator light will shut off, the LED
lights will shut off, and the heating elements will shut
down.
9

OPERATION

Heat Control
Knob