Operation; General - Hatco HBG Série Manuel D'installation Et D'utilisation

English

General

Use the following procedure to turn on and operate a Heated
Glass Shelf.
WARNING
Read all safety messages in the IMPORTANT SAFETY
INFORMATION section before operating this equipment.
NOTICE
Do not turn on unit until it has been cleaned thoroughly.
Ceramic glass surface must be clear of debris to prevent
burn-on.
Use only wipes, pads, and cleaners designed specifically
for cleaning ceramic glass surfaces. Using other wipes,
pads, or cleaners may damage ceramic glass surface.
Do not slide pans across glass surface, use rough-
bottomed pans, or drop anything on glass surface.
Scratching or breakage may occur. Damage to glass
surface or breakage of glass caused by misuse is not
covered under warranty.
Form No. HBGM-0120
Power I/O (on/off)
Switch
Standard Control Panel
9
Startup
1. Using an appropriate cleaning wipe or a damp cloth, clean
the glass surface of the unit. Consistent daily cleaning will
keep cleanup easy as well as protect and preserve the
glass surface of the unit.
2. Plug unit into a properly grounded electrical receptacle of
the correct voltage, size, and plug configuration. See the
SPECIFICATIONS section for details.
3. Move the Power I/O (on/off) switch to the I (on) position.
BURN HAZARD: Some exterior surfaces on the unit will get
hot. Use caution when touching these areas.
4. Turn the temperature control to the desired temperature
setting.
NOTE: Turning the temperature control clockwise will increase
the temperature setting. Turning the temperature
control counterclockwise will decrease the temperature
setting.
5. Allow the unit 30 minutes to reach operating temperature.
NOTE: Refer to the OPTIONS AND ACCESSORIES section
for installation and operation information for HBGB
units equipped with the flush mount control box.
Shutdown
1. Move the Power I/O (on/off) switch to the O (off) position
and allow the unit to cool completely.
2. Perform the "Daily Cleaning" procedure in the
MAINTENANCE section of this manual.
Temperature Control

OPERATION

CAUTION