General; Fire Hazard; Installation - Hatco Ultra-Glo Manuel D'installation Et D'utilisation

English

General

Use the information in this section to prepare for installation of
the strip heater. Make sure to locate the specific information for
the model of strip heater and type of installation. Ultra-Glo
Heaters are shipped with most components pre-assembled.
Dual units come with a required 3" (76 mm) or 6" (152 mm)
spacer pre-assembled at the factory.
Optional mounting equipment and remote control enclosures
must be installed on location.
WARNING
FIRE HAZARD: Do not install unit above or around
combustible surfaces. Discoloration or combustion
could occur. Unit must be installed in non-combustible
surroundings only.
Ensure safe and proper operation. Refer to the "Minimum
Clearance Requirements" listed in the INSTALLATION
section of this manual.
NOTICE
Damage to any countertop material caused by heat
generated from Hatco equipment is not covered under
the Hatco warranty. Contact manufacturer of countertop
material for application information.
Do not add a decorative soffit to hide a pass-through
mounted strip heater. Premature failure of components
due to excessive heat may occur.
NOTE: Contact the countertop manufacturer of the base
material for application information and surface
temperature limits before installing the unit.
1. Remove the unit from the shipping carton and remove all
packing materials.
NOTE: To prevent delay in obtaining warranty coverage, complete
online warranty registration. See the IMPORTANT
OWNER INFORMATION section for details.
2. Remove tape and protective packaging from all surfaces
of the unit.
NOTE: If unit is equipped with optional equipment, see the
OPTIONS AND ACCESSORIES section near the back
of this manual.
3. Install/mount the unit in an appropriate location.
a. Verify recommended mounting heights and minimum
clearance requirements are met for the appropriate
model. Refer to "Recommended Mounting Heights" and
"Minimum Clearance Requirements" in this section.
b. For angle bracket mounting installation, refer to
"Undershelf Mounting" in this section.
c. For tubular stand mounting installation, refer to
"Permanent Surface Mounting" in this section.
d. For overhead hanger post installation, refer to "Overhead
Mounting" in this section.
Form No. UGAM-0718
CAUTION
Dual Mounting
When mounting units side-by-side, a space not less than
3" (76 mm) must be maintained between units. Dual units
ordered from the factory are shipped with a pre-assembled 3"
Strip
®
(76 mm) or 6" (152 mm) spacer.
Installation of two or more separate units with less than
3" (76 mm) between housings may result in premature
failure of component parts. Failure to provide proper
spacing may result in heat damage to electrical
components.
Under Shelf Mounting
When mounting a unit under a shelf, use adjustable angle
brackets to assure proper spacing. Remote control enclosures
are recommended to keep switches out of the heat zone and
prevent premature failure.
Pass-Through
If pass-through area is 12" to 16" (305 to 406 mm) deep, a
single unit can be used. For a 20" to 24" (508 to 610 mm) deep
pass-through area, a dual unit is recommended. Installation
of multiple units must have a minimum spacing of 3" (76 mm)
between heaters.
Over Steam Table
When mounting over a steam table, a remote control enclosure
must be installed.
15

INSTALLATION

NOTICE