Operation; General - Hatco Glo-Ray GRN4 Série Manuel D'installation Et D'utilisation

English

General

Use the following information to operate a Glo-Ray
Halogen Strip Heater.
WARNING
Read all safety messages in the IMPORTANT SAFETY
INFORMATION SECTION before operating this equipment.
Standard and approved manufacturing oils may smoke up
to 30 minutes during initial startup. This is a temporary
condition. Operate unit without food product until smoke
dissipates.
Startup
1. Move the HEAT ON/OFF (I/O) switch to the ON (I) position.
The halogen heat lamps will illuminate.
2. Turn the HEAT control knob to the desired setting.
3. For GRN4L Models, move the LIGHTS ON/OFF (I/O)
switch to the ON (I) position. The Xenon display lights will
illuminate.
BURN HAZARD: Some exterior surfaces on unit will get
hot. Use caution when touching these areas.
4. Allow 30 minutes to reach operating temperature before
holding food product underneath the strip heater.
Shutdown
1. Move the HEAT ON/OFF (I/O) switch to the OFF (O)
position.
2. For GRN4L Models, move the LIGHTS ON/OFF (I/O)
switch to the OFF (O) position.
Form No. GRN4M-1017
CAUTION
CAUTION
Narrow
®
HEAT Control
LIGHTS ON/OFF
(I/O) Switch
HEAT Control
9

OPERATION

GRN4 Control Box
HEAT ON/OFF
(I/O) Switch
Knob
GRN4L Control Box
HEAT ON/OFF
(I/O) Switch
Knob
GRN4 and GRN4L Control Boxes