Symbol Meanings; Delivery Checklist - Hettich ROTIXA 50 S Mode D'emploi

EN
For further details of available biosafety systems see chapter "Anhang/Appendix, Rotoren und Zubehör/Rotors
and accessories". If in doubt, you should obtain relevant information from the manufacturer.
•
The centrifuge must not be operated with highly corrosive substances which could impair the mechanical integrity
of rotors, hangers and accessories.
•
Repairs must only be carried out by personnel authorised to do so by the manufacturer.
•
Only original spare parts and original accessories licensed by the Andreas Hettich GmbH & Co. KG company are
allowed to be utilised.
•
The following safety regulations apply:
EN / IEC 61010-1 and EN / IEC 61010-2-020 as well as their national deviations.
•
The safe operation and reliability of the centrifuge can only be guaranteed if:
− the centrifuge is operated in accordance with the operating instructions,
− the electrical installation on the site where the centrifuge is installed conforms to the demands of EN / IEC
stipulations,
− prescribed tests to BGV A1, BGR 500 are carried out by an expert.
5

Symbol meanings

Symbol on the machine:
Attention, general hazard area.
Before using the centrifuge implicitly read the operating instructions and pay attention to the safety
relevant references!
Symbol in this document:
Attention, general hazard area.
This symbol refers to safety relevant warnings and indicates possibly dangerous situations.
The non-adherence to these warnings can lead to material damage and injury to personal.
Symbol on the machine and in this document:
Beware of hot surface.
Nonobservance of this warning can lead to material damage and personal injury.
Symbol on the machine and in this document:
The plastic buckets, order no. 5091, may only be used for temperatures up to a maximum of 40°C.
Nonobservance of this warning can lead to material damage and personal injury.
Symbol in this document:
This symbol refers to important circumstances.
Symbol on the machine and in this document:
Symbol for the separate collection of electric and electronic devices according to the guideline
2002/96/EG (WEEE). The device belongs to Group 8 (medical devices).
Applies in the countries of the European Union, as well as in Norway and Switzerland.
6

Delivery checklist

1 Connecting cable
1 Fuse T 2 A; 250 V
1 One opend-end wrench (8 mm)
1 Lubricating grease for trunnions
2 Distance bolt
2 Setting foot bolt
2 Setting foot bushing
1 Square spanner
1 Release pin
1 Operating instructions
3 Program-data sheet
1 Information on how to remove the packing
1 Installation information sheet
The rotor(s) and associated accessories are included in the delivery in the quantity ordered.
30/104