Breitling COCKPIT B50 Mode D'emploi page 80

If the date was displayed,
process will start with adjusting the date. In the second case, press on P2 until
the hours begin to flash (
• By turning the crown, adjust the time in relation to difference with UTC, from
to
UTC-12 UTC+14
• Confirm by pressing P2; the minutes flash (display
• If necessary, adjust the minutes in 15-minute increments and confirm by pressing
P2; the seconds flash (
• Adjust the seconds (which will automatically be adjusted in the
and confirm by pressing P2.
• Press the crown back to neutral position 1.
N.B.: When in setting mode (
from 0. The seconds counter only stops when the seconds are manually modified. In
this case, it restarts when exiting setting (putting the crown back to neutral position
1). The seconds are automatically synchronized on the
In mode, pressing P1 makes it possible to go into
TIME
date according to different formats (see chapter 8). A long press on P1 puts the
display directly back to
In mode, a long press on P2 allows to choose between either the 12-hour (AM
TIME
or PM indicator) or the 24-hour display. The change also happens automatically for
the TIME 2 zone and two alarms.
SETDATE
xx).
UTC +/-
.
appears on the upper screen).
SECOND
SETTIME
.
TIME
appears on the upper screen and the setting
MIN +00
), pressing P1 will restart the seconds counter
79
) on the upper screen.
TIME 2
and
UTC TIME 2
mode and display the
DATE
and )
UTC
timezones.